- Certified - Description
- Additional Information
The Deluxe Inspector Gage Pouch is a custom pouch made by Atema that includes the tools necessary for weld inspection. The pouch is 8″ x 5″ ~3″ thick with external slots to add more tools or clip on a small tape measure or other tools. The pouch includes:
- Certified- 7 Piece Fillet Weld Gage Set
- Certified- Undercut/Reinforcement Weld Gage
- Temperature crayons - 150 & 250 degree*
- Depth Gage & Protractor
- 6" Steel Rule
- Paint Marker
- Gearlight S1000 Flashlight
- Wire Brush
- Soap Stone Holder & Soap Stone
Gages come with certified calibration documentation highlighting calibration was performed in accordance with ISO 17025:2017, ANSI/NCSL Z540-1, Mil-STD- 45662A, Webber Quality Manual QCM-1G dated 11/15/14, and Webber Calibration Procedure WCP-C13 9/6.2006. Traceable to NIST. The numbered and registered gages are manufactured and tested to tolerances not to exceed +/- .006 (or +/- .15mm) tolerance level. These gages meet or exceed all requirements for the American Association of Railroads and the Federal Railroad Administration. These gages are direct contact instruments and some wear will occur after usage. The purchaser should periodically re-calibrate these gages or return them to Atema for recalibration and recertification. This assures that excess wear has not compromised the accuracy of the instruments.
A note on calibration dates: Calibration dates are suggested by the manufacturer. You may select a re-calibration date with an interval of your choosing, as long as this is documented in your Quality Manual or other quality documents. Atema recommends a 5 year re-calibration date for gages used as a Master set.